Be it a small crack or a huge one, water always finds its way. And there are several reasons as to why water enters your basement. Flash floods, drainage problems, and appliance failures are some of them. When water accumulates in the basement, it becomes a ground for mold and termites to grow. If you want to avoid this from happening, you can get in touch with one of the water damage restoration companies. You can also indulge into some DIY steps for preventing water getting into your basement. Here’s what you can do to keep the water out.
As mentioned above, water has a tendency to leak through cracks. If there are gaps around plumbing pipes or concrete walls, water can enter into a basement. Make use of polyurethane caulk or hydraulic cement to seal those gaps. Check if the water still enters after sealing. If it still does, you might have to resolve the groundwater problem as mere sealing won’t work.
The downspouts that help you to get rid of excess water should be kept five feet away from the house. You can do so by adding metal or plastic extensions to the downspouts. You can also install an underground drain pipe so that the gutter runoff remains far from your house.
Moisture and condensation often form on the basement walls. Apply sealant on the walls to avoid this from happening. Apart from this, you can also waterproof the basement walls with silicate based concrete sealers, concrete coatings, plastic sheets or waterproofing paint. Also consider waterproofing the outside walls of the basements so that you can fill the gaps in the foundation if there are any. This process might prove too expensive as you will need to excavate around the house.
When you install a sump pump, it will protect your basement during floods by pumping the water out. If the level of water in the basement goes up, the sump pump is smart enough to discharge the water outside the house. But before installing one of these for your house, conduct research on how to find the right sump pump and use it.
When the gutters are blocked, it results into the water pouring in your home’s foundation creating the risk of basement flooding. Hence, make sure that you get rid of leaves or branches, debris etc and check if there are any loose particles from the asphalt roofing in the gutters. If there are any loose gutter straps, you must tighten them. In case of any gunk in downspouts, you can get rid of them by pouring a lot of water with the help of garden hose.
If your basement is already flooded, you must get in touch with the water restoration service provider so that you do not have to deal directly with floodwater. If not, you can take the steps mentioned above and protect your basement.